Hey all, I just finished my project designing and 3D printing an enclosure using a Raspberry Pi 5 8GB, Radxa’s penta SATA HAT and Top Board paired with Qty4 WD 4TB Reds
I ran a quick test to check the speed and it’s not looking too bad. 200MB/s!
Penta SATA HAT & Top Board with Raspberry Pi 5
Looks great! I’m building the same NAS now. Out of curiosity, what did you use for your power supply? I’m concerned about the 12V 5A not being powerful enough to power the 3.5 HDDs along with the hat, fans, pi, etc. Was planning on ordering a 12V 6A power supply, but not sure if that would cause any issues?