Updated CAD model of Rock Pi S and POE hat?

#1

Hi All,

I’ve just ordered a pair of Rock Pi S boards and POE hats to go with them. I need to break out some of the UARTs, and since the POE hat with passthrough connectors doesn’t seem to available, I was planning to design a breakout board that slots in between the Rock Pi and the POE hat.

However, I can’t find any information about the position of all the headers. The Rock Pi S 3D model (on the wiki) doesn’t include the POE headers. The 2D CAD model on the Rock Pi S POE Hat page is actually a model of the normal Rock Pi (ie not S) POE hat and is therefore completely unsuitable. Is that information available anywhere?

Thanks!

#2

As you can see they do not update info on the PoE HAT to include the right 2D drawing, which is unavailable. I contacted them by email and ignored the request too.

Very poor support from Radxa indeed.