Rock Pi S SPI1 Clock

I am experiencing an issue with my Rock Pi S. When using SPI1, I am not observing any CLK output signal on pin GPIO3_B3, which I have verified with an oscilloscope. I have found that this issue does not occur in the older kernel 4.4.143-65-rockchip-g58431d38f8f3. However, when using the latest image rock-pi-s_debian_bookworm_cli_b40, this problem arises. I have also observed the same issue when using the Armbian distribution.

Could someone please assist me in resolving this problem?

What is the hardware version of your board? I’ll check it.

I have version V13.

is this all support from radxa?

Hi @Martin_Petrasovsky

Sorry for the inconvenience.

The PI-S SPI-1 bus and I2C3 are not working properly due to a problem with the RK3308 GPIO supported in the mainline kernel.

We recommend that you replace the SPI pins or continue to use the RK 4.4 kernel.