Not sure if this applies to other editions, but I noticed the PoE hat physically covers all the GPIO pins - is there a way to break these out so they’re easy to access?
Also, are there any pins unavailable due to the PoE hat using them?
Lastly, is the assembly of M2 + M2 board + heatsink underneath, compatible with the PoE hat going on top?
You can consider the F4L model, which 40PIN GPIO pass-through exported.
The pin#13 and pin#26 are occupied, you can check the page.
Is this the heatsink? If so, M2 and M2 board cannot be assembled underneath.
Ah thank you @setq - I’d ruled that part out as I didn’t need the 23W.
.
Well, the heatsink + M2 are the priority, so I’ll mount the PoE nearby - probably onto the lid of a 3D printed case or something.
.
Do I need to wire any other PINs than #13 and #26 to make it work? The wiki page mentions several others.
Thanks! 