Radxa 4 SE wont boot with any usb 3 port populated

Hello everyone.

Whenever I power on my 4 SE with any usb 3 device attached to the port, powered or not it will not boot. Its only when I remove any usb 3 device attached and power cycle again will it actually post and boot.

It does not effect the usb 2.0 ports at all. Bit annoying if I want to control boot remotely using a power hat or what have you. For some future projects I dont intend on being next to it to pull out and reinsert cables.

Anyone have any suggestions as to what might be causing it.

Maybe it’s the power input that is to low? I use a 29W usb charger to power up my 4SE.

1 Like