Hello fellow forum members,
I hope this message finds you well. I am currently facing an issue with my Okdo Rock 4C+ board while working on Jackd. I have a USB microphone connected and Bluetooth earbuds paired, but I’m unable to achieve simultaneous capture and playback using qjackctl.
When I navigate to the settings parameters in qjackctl, I’ve tried various interface options, but none of them seem to provide me with the desired two capture channels from the USB microphone and two playback channels for both the right and left Bluetooth earbuds.
Here are the interface options I have attempted, without success:
- hw:rockchiphdmi0
- hw:rockchiphdmi1
- hw:rockchiprk809
- hw:rockchiprk809,0
I have spent a considerable amount of time troubleshooting this issue, but so far, I haven’t been able to find a suitable solution. Therefore, I am reaching out to this knowledgeable community in the hope that someone can provide me with guidance or suggestions on how to overcome this problem.
If anyone has encountered a similar situation or has experience with configuring Jackd on the Okdo Rock 4C+ board to enable simultaneous capture from a USB microphone and playback to Bluetooth earbuds, I would greatly appreciate your assistance.
Thank you in advance for your time and support. I look forward to your valuable insights and suggestions.
Best regards,