Hey I have a ROCK 5C board I need to use CAN Bus on it to send the data I have gone through the document in the Interface section. I am not able to see ‘Enable CAN1-M0’ in the Overlays I am getting ‘rk3588-spi0-m1-cs0-mcp2515-8mhz’. I am using a “TJA1050 CAN Controller Bus Driver Interface Module” to connect CAN Rx and CAN Tx to Rock 5C and CAN H and CAN L Microchip CANAnalyzer to check the interface of the CAN bus from the ROCK 5C to the CANAnalyzer. After connectng and giving the command the can node is not getting detected.
I tried using the third party overlay using the github repo
https://github.com/radxa-pkg/radxa-overlays/blob/main/arch/arm64/boot/dts/rockchip/overlays/rk3588-can1-m1.dts
I was able to see the CAN1 M! overlay enable in my Manage Overlay using rsetup
But still when I am connecting my module to the CAN Bus I am not able to detect the CAN Bus on the ROCK 5C Board
Please help me in enabling the CAN Bus on ROCK 5C.