3D printed case for ZERO3E

Hello, i’ll drop here a link to a printable case i did.

This is my first ever 3D model, so it may have some flaws.
Enjoy!

https://www.printables.com/model/922305-radxa-zero3e-case-by-nenter

3 Likes

Looks adorable, thanks for sharing :smiley:

Here is another convenient version of the case made of two halves without active cooling for zero 3w. I’ll add it later for version E when it becomes available.

@Typeof_undefined In the last 3 months that I’ve been using the Zero 3W, I’ve found that on CPU intensive tasks (eg. native kernel builds), the board quickly ramps up to 80 degrees C without active cooling. but stays down to to 50C with a 5v 3010 fan. I’ll suggest adding an opening for a 3010 or even a 5v 2507 fan.

I might add a fan in one of the next versions of the case. The main purpose of this case was to provide protection against accidental damage to components. I will check the temperature with a stress test. During the time of operation I did not have any problems with overheating.