I have Issues with Booting Radxa Rock 5

#1

Hey guys…:wave:

I am having trouble booting up my Radxa Rock 5. I followed the installation instructions, but when I power it on, the device doesn’t seem to start up properly. The power LED is on, but there’s no signal to the monitor and I’m not hearing any boot sounds.

I have tried re-flashing the image and checking all the connections, but the issue persists. Has anyone else experienced this problem or have any suggestions for troubleshooting?

I also check this: https://forum.radxa.com/t/radxa-rock-5b-pcie-and-rtl8125b-networking-in-u-bootqlik But I have not found any solution. Could anyone guide me about this?

Thanks in advance!

Respected community member!:smiling_face_with_three_hearts:

#2

What software did you use to write the SD card?

#3

Have you or can you connect to the serial console to see if the boot loader sequence is executing? https://wiki.radxa.com/Rock/Serial_debug_tools_Setting

#4

Check the FAQ I wrote in the Rock 5 category: [Guide] Rock 5 series boards - troubleshooting FAQ for newcomers

Btw, there won’t be any boot sounds because ARM boards don’t really do canonical POST.

Also, there are multiple Rock 5 models, are you sure you are using the Rock 5b image with the rock 5b board?